Honda Valkyrie Air Horns Installation Instructions
download Horns: Remove the stock horn by unplugging the wires and removing the 12mm acorn nut. This will leave an 8mm stud exposed. Notice in the hardware kit there are two brackets supplied. Locate...
View ArticleVICTORY HAMMER, KINGPIN, VEGAS AND JACKPOT ELECTRIC HORN INSTALLATION...
download 1. Remove the left and right plastic side covers and the seat (two allen bolts located below the sides of the seat). Unplug and remove the stock horn (located over the oil cooler). Connect the...
View ArticleStreet Magic Magical Wizards LED Installation Instructions
download 1. Always wear appropriate safety gear including safety glasses when soldering or performing any electrical work. It is highly recommended that safety glasses be worn throughout this...
View ArticleHARLEY DAVIDSON ELECTRA-GLO LIGHT POD KITS INSTALLATION INSTRUCTIONS
download INSTALLATION NOTES Clean the controller mounting area and the areas where the light pods will be mounted with soap and water before beginning the installation, and allow to dry thoroughly....
View ArticleHonda ST1300 Front Panel Kit installation
download STEP #1 – Expose the battery by removing the seat & side panels on the rightnside of the bike. See the Honda service manual. If you are not familiar with this procedure, have a trained...
View ArticleHonda TRX 400EX INSTALLATION And REMOVAL INSTRUCTIONS
download Quiet cores are supplied with this kit but not installed. To install the quiet cores remove both rear end caps ((turn downs) and install the quiet cores with the tubes facing inward....
View ArticleSUZUKI PKT-045 V-STROM LEFT FRONT PANEL Installation Manual
download STEP #1 – Remove the seat & the left side fairings. See the Suzuki service manual. STEP #2 – Drill a 18mm hole into the panel (11/16″ hole saw recommended and is available on our site)...
View ArticleHarley Davidson Power Pod Switch Housing Throttle Bracket Installation...
download Attach the “Y” bracket to the Power Pod by using the two Power Pod socket head screws that come in your parts kit. (This bracket may already be attached from the factory. ) 2) Remove the two...
View ArticleHARLEY-DAVIDSON Starter Relay Location Guide
download Touring 1998 – 2007 Additional Notes: Relay Location: Under Seat in rubber Boot Battery Connection: Under Seat,Visiable Installation Notes: No Access Issues Factory Relay Type: FULL SIZE...
View ArticleHarley-Davidson Mid Kit POWERLET Installation Instructions
download STEP #1 Remove seat. STEP #2 Route wires starting at the battery end and finishing at the bracket. STEP #3 Connect the wires to the socket. STEP #4 Mount the bracket on the horn bracket...
View Article
More Pages to Explore .....